• Suomi
  • English
  • Русский
  • Svenska

C2 SmartLight Sensors

Light Sensor

One to nine (1–9) sensors are installed in the area with least obtrusive light. The average of the measured values is used as a control parameter.

All measurements are recorded and available in the user interface.

The system notifies failures and omits the measurement of the broken sensor from the average.

The sensors measure the luminance of the area all the time, but are specifically sensitive to luminance between 0–50 lux.

Features
Communication Signal Encrypted data via cable
Glass Pilkington ActivTM self-cleaning
Thickness of glass 4 mm
Bus +5 V DC I2C-Bus / cable 4 m / RJ45
Measurement range 0-6553 lx
Operational Temperature -40 to +60 Celsius

 

Temperature Sensor

C2 SmartLight Temperature Sensor measures the ambient temperature.

Typical use cases of temperature sensor are different kinds of sport fields that are not in use when the temperature is too low. Also, the temperature sensor can be used to keep the lighting switched off e.g. on skating rings when the temperature is above 0 C.

The temperatures limits are programmed and updated via C2 user interface.

Features

Communication Signal Encrypted data via cable
Glass Pilkington ActivTM self-cleaning
Thickness of glass 4 mm
Bus +5 V DC I2C-Bus / cable 4 m / RJ45
Measurement range -40 to +40 Celsius
Operational Temperature -40 to +60 Celsius

 

Push Button

In areas, where a motion sensor does not provide the accuracy needed for the light switch-on – e.g. in areas near pedestrian pathways with people passing by – a push-button can provide the right means for triggering the lighting.

The C2 SmartLight Push Button is vandal-safe, and designed for demanding outdoor conditions. The button is wireless and thus does not require new control cabling.

• Vandal-safe

• Weather-proof

• Wireless

 

 

Painonappi2

Motion Sensor

The C2 SmartLight Motion Sensor ensures that the lights are on only when there are users on the area, or alternatively, that the dimmed lighting brightens when a user enters the area.

The Motion Sensor is connected to the C2 SmartLumo 230 VAC controller which sends a signal to the luminaires when motion is detected.

• On-demand lighting

• Weather-proof

• Wireless

 

 

C2 Motion Sensor